Where to get a TH400 built.

[mysticcobra]

I was wondering if anyone local in MN has a place that they would trust getting a th400 built for them? As far as what I'm looking for I would like it to be able to withstand 1000hp/tq. And have a trans brake.

[chevyguy15]

http://mastertransmission.com/

i had them refresh my c4, 727, they are taking the power plus nice guy to work with and will be going there more.

[tirenick]

http://mastertransmission.com/

i had them refresh my c4, 727, they are taking the power plus nice guy to work with and will be going there more.

Yep!!! John did mine in my chevelle. 3600 lbs and 8.40 at 160...
Dude knows his tranny stuff for sure!

[Joe M]

Bluchev (Chad) on here does them as well.

Master Trans built the AOD that is in my bronco... 2x... I broke it on day 2... I got a free upgrade

[shagwag]

Steve turnquist has always done my stuff 755 1134

[mysticcobra]

http://mastertransmission.com/

i had them refresh my c4, 727, they are taking the power plus nice guy to work with and will be going there more.

I will have to talk to him about a qoute.

[mysticcobra]

Steve turnquist has always done my stuff 755 1134

Does this guy just do it on the side? Or does he have a shop?

[mysticcobra]

Anyone in here have any good cores laying around?

[Notch]

I have a good case with internals. Clutches were fried and rear carrier is all rusty. Will sell cheap if itll work for ya.

[shagwag]

Its a shop, transformation performance

[94fobrah]

I dropped my c4 off at master today, John seemed like a nice guy.

[Scorpner]

Steve's been building tranny's for years and only heard good things. Same for Chad, Master Transmission and Eric Streed at Kennedy Transmission in Bloomington. All performance builders known over the years.

http://www.kennedytransmission.com/bloomington-transmission-service/

[taank]

I vote Bluchev.

[chevyguy15]

Steve turnquist has always done my stuff 755 1134

steve is the original person that built my C4. speced it to 750 hp took over 830 rwhp all summer and never slipped once. i had it refreshed by John and it looked pretty good for what i was doing to it. cant go wrong with either guy

[mysticcobra]

Talked to a couple guys and they convinced me into running a powerglide based on my setup. So I called up Richard at Mean Street and he is ordering one for me.