Tweet
FRPP 'B' springs (again). Put them in last night. Only the lower isolators are installed...I may add the top ones in the front; car has a little too much forward rake now. Lowered it 1.5" in front and 1" in the rear.
-
-
MUCH Better
-
looking good kris
Outta Control Racing Ooo
HTM high compression 306 319 Hp 342 Tq
Stock headed 302 281HP/322TQ HTM E-85 Tune
http://www.hitechmotorsport.com/Comment
-
I'd let the springs settle a bit before you do anything. The height might change.
And put the wing back!
Looks great.
Last edited by punch; 02-09-2005, 02:12 PM.Comment
-
looks sweet! I can't believe they just don't lower them right from the factory! I allways hated the way the '94+ sat as far as stock height!
Ride:
'97 Mustang GT a.k.a. BLACK SUNSHINE!!Comment
-
looks good kris.
O.C.R.
I make horse powerzComment
-
I really should do that too.
The few lowered black machs I have seen look really mean.
Am too lazy to do the work though.
BSM FlunkeeComment
-
Looks good Kris. Can't wait to see it up close.
Hey, whatcha doin' driving that thing in the snow
"A train station is where the train stops. A bus station is where the bus stops. On my desk, I have a work station... you figure it out ..."Comment
-
looks great what are you going to do next?
Comment
-
that looks good. are you thinking about keeping those rims and tires on there throughout the summer or do you have another set just for driving around? i was thining about getting some draglites or something for the trackComment
-
sweet looking car! the wheels and winglessness look badass. Any power adding mods yet?Comment
TCS Auto-X Driver
Comment