Installing Kirban fuel regulator?

[Wislnby]

Is there supposed to be a gasket between the rail mount and the regulator? The regulator(Kirban) has the o rings, just need to know if there should be a regular gasket too. The BBK that I just took off had a small gasket that did not cover the whole flat mounting area. Should I reuse that?

Thanks, buy the way this is on a 94 GT

[lilstang5O]

on the 5.0's then yes. It should be a small rubber gasket I believe, I re-used mine and had no problems and then when I went back to stock I had no problems with it either.

[Stormwalker]

When I installed the Kirban, it just had the o-ring, but I think the factory one was the same way. I just installed it as is, I don't remember any additional gaskets or anything.

[Wislnby]

I didn't use any gaskets and it is not leaking, so I guess I'm good to go. There was one small gasket that is recessed around the vacume port that I did use.

[Mark302]

I have never used a gasket either.