Faceplated T-56

[camrsz]

faceplated T-56 , has just been serviced with new 4th gear plate installed by Liberty, 5th gear, 5/6 synchro assembly, and 5/6 cluster gear since the splines were worn. 5/6 cluster gear now press fits to splines. Trans originally faceplate converted by sixspeeds and has bronze fork pads and viper output shaft conversion. Has stock style input shaft. Will include all leftover parts from original conversion as well as parts recently replaced, and remnants of shim kit if desired. Front and rear seals are new. comes with ls1 bell housing. I do have a clutch, flywheel, shifter, slave cylinder for sale as well
asking 2400$ for trans

[Sleepin96]

I need to sell some shit fast!

[Slow35th]

I need to sell some shit fast!

Its for an ls motor. I belive you need to swap input shafts and bell to make it fit a mod motor.

[Slo_GTS]

I think he needs an lsx engine too

[Notch]

I think he needs an lsx engine too

This. Not the wrong bellhousing, just the wrong engine

[camrsz]

Its for an ls motor. I belive you need to swap input shafts and bell to make it fit a mod motor.

I see the parts needed to make it work on ebay often.

[camrsz]

still for sale

[camrsz]

will include shifter, fly wheel, clutch and slave for free

[327 mustang]

what clutch and flywheel are they? also can u make it a cable clutch for in a mustang my dads putting a ls in his car and its a manual already

[camrsz]

what clutch and flywheel are they? also can u make it a cable clutch for in a mustang my dads putting a ls in his car and its a manual already

probably be easier to convert the car to hydraulic master and use the stock slave i have for it. stock flywheel,clutch is a textralia with a six puck disc.

[327 mustang]

so is this for a 6.0 or 5.3 because i think with a 5.3 u have to run a flywheel spacer correct?

[camrsz]

so is this for a 6.0 or 5.3 because i think with a 5.3 u have to run a flywheel spacer correct?

the flywheel is from a ls1 not sure about the spacer never ran a 5.3

[camrsz]

still for sale spring will be here before you know it.

[01darkblueTA]

damn this is tempting. steel 3/4 fork too i assume?

[94fobrah]

damn this is tempting. steel 3/4 fork too i assume?

Dont be dumb, go auto.