Tweet
86 Mustang GT
Selling my 86 mustang GT drag car. Car is clean and never seen winter. 68,000 miles, Car is a hatch back with T-tops
Car has stock interior with 8 point roll bar, have full chrome molly roll cage for it that I will though in for free if someone doesn’t buy the cage first.
Through the floor sub frame conectors.
Wolf Racecraft anti sway bar
Body and paint is fair condition
Engine…Ford motorsports A4 block bored .03 over. 4 bolt mains
Cola crank 3.25 stroke zero balanced
Eagle connecting rods 5.4 length.
JE pistons
Comp cams solid roller camshaft.
TFS aluminum street heat heads ported.
T&D shaft mount rockers 1.65 ratio
Danny bee belt drive
CSI electric water pump
Moroso oil pan with windage screen.
Custom intake with sheet metal upper.ported to match heads
Accel DFI fuel injection
83LBS injectors.
90mm throttle body
Vortech J trim mondo super charger. 10 passes on rebuild
50mm cog drive
Reactor performance aluminum flywheel.
Dynamic C-4 transmission with brake, 8” 5500 stall converter
Aluminum drive shaft.
Moser 31 spline axles
3.73 gears with spool.
Weld wheels 15x8 on the rear 15x3 front runners
Weldon 2025 fuel pump with sump in the tank
There is more that I’m forgetting, best thing to do is come that a look at it and bring money.
This is a smoking deal it would cost about $10,000 for the same motor.
Will throw in the spare parts I have also, new roller lifters, valves ect.
$10500.00
612-803-2578 or e-mail deansibik@hotmail.com
Car has stock interior with 8 point roll bar, have full chrome molly roll cage for it that I will though in for free if someone doesn’t buy the cage first.
Through the floor sub frame conectors.
Wolf Racecraft anti sway bar
Body and paint is fair condition
Engine…Ford motorsports A4 block bored .03 over. 4 bolt mains
Cola crank 3.25 stroke zero balanced
Eagle connecting rods 5.4 length.
JE pistons
Comp cams solid roller camshaft.
TFS aluminum street heat heads ported.
T&D shaft mount rockers 1.65 ratio
Danny bee belt drive
CSI electric water pump
Moroso oil pan with windage screen.
Custom intake with sheet metal upper.ported to match heads
Accel DFI fuel injection
83LBS injectors.
90mm throttle body
Vortech J trim mondo super charger. 10 passes on rebuild
50mm cog drive
Reactor performance aluminum flywheel.
Dynamic C-4 transmission with brake, 8” 5500 stall converter
Aluminum drive shaft.
Moser 31 spline axles
3.73 gears with spool.
Weld wheels 15x8 on the rear 15x3 front runners
Weldon 2025 fuel pump with sump in the tank
There is more that I’m forgetting, best thing to do is come that a look at it and bring money.
This is a smoking deal it would cost about $10,000 for the same motor.
Will throw in the spare parts I have also, new roller lifters, valves ect.
$10500.00
612-803-2578 or e-mail deansibik@hotmail.com
Comment