If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
RX7 Turbo V8 at Porkys... 'ala Fast Eddy style....
yes i think most of us sbc guys are using grannys mounts. my hood fit on with no holes when is was n.a. now i will have to work something out. i will be done with the exhaust in about another hour.
yes i think most of us sbc guys are using grannys mounts. my hood fit on with no holes when is was n.a. now i will have to work something out. i will be done with the exhaust in about another hour.
A friend has done 2 RX7's, one is a 383 that runs 7.2X's in the 1/8th. I actually just bought a white 86 RX7 2+2 with a bad roatary for one of these swaps. So I just built a 11:1 406 with Etec 200 heads, solid flat tappet cam and performer RPM intake with a holley HP 750 carb, 700R4 with all the good parts and a edge converter. I have most of the parts collected to start in, just need the time. I never knew there were quite a few of these conversions around.
A friend has done 2 RX7's, one is a 383 that runs 7.2X's in the 1/8th. I actually just bought a white 86 RX7 2+2 with a bad roatary for one of these swaps. So I just built a 11:1 406 with Etec 200 heads, solid flat tappet cam and performer RPM intake with a holley HP 750 carb, 700R4 with all the good parts and a edge converter. I have most of the parts collected to start in, just need the time. I never knew there were quite a few of these conversions around.
that would be a wicked motor in an rx7, hurry up i wana see it!
Comment