1967 Ford Mustang Fastback Seat Removal

[67Fastbackguy]

Hello

I recently purchased a restomod fastback. I am a tall driver and cannot drive/operate the clutch properly or comfortably with the seat in its most rear position. I have contacted KustomClassics, the seller of the seats from the previous owner, and the will manufacture me a set of extension rails so i can modify the seat.

My question is: i looked under the seat and saw the rails but there is no bold i can loosen from the inside of the car under the seat, to remove it.

Can someone please guide me on how to remove the seat so i can install the rails?

Thanks

[flstci71]

Typically, late 60's Ford seats are attached by tracks that are bolted through the floor. You will need to go under the car to unbolt the track from the floor pan. Old paint, undercoating, and rust can make this a less-than-fun exercise.

[67Fastbackguy]

Typically, late 60's Ford seats are attached by tracks that are bolted through the floor. You will need to go under the car to unbolt the track from the floor pan. Old paint, undercoating, and rust can make this a less-than-fun exercise.

Thanks! Found them. The four holes were covered by grommets. Once I removed the
I see the bolts.

I'll get some ramps and undo them this weekend.


Sent from my iPhone using Tapatalk